The Pro Bike Tool 3 Bike Wall Rack is a neat all-in-one solution to storing multiple bikes to help you save floor space. It's a slightly more expensive route to take than buying individual bike-specific hooks, but the end product is, I'd argue, much better overall.
Tired of putting your beloved bikes up against each other, potentially scratching them and making each one difficult to access? Pro Bike Tool's storage rack is a simple but elegant solution to the problem, and as it's designed to mount up to three bikes (or six, if you choose its bigger brother), it's great if you have an N+1 addiction.
Consisting of a neat-looking aluminium bar with three hooks that slide onto a rail, the PBT rack is designed to be mounted high (at least 180cm from the ground) so that bikes attached to it hang vertically.
The rack can be used in a garage, shed or even inside your house, and can be mounted to plasterboard (provided it's supported by wooden studs) or something a bit more solid like masonry or concrete.
The hooks used are quite substantial and are suitable for tyres up to 5 inches wide, so there's plenty of scope to hang up pretty much any type of bike you wish.
The rack is rated for a total of 90kg in hanging weight – if you happen to have three bikes that weigh over 30kg each, then we salute you.
Handily, all the bits you need to install the rack are included in the pack – even the tools needed to tighten the bolts with.
Installation is a breeze – if you're attaching the rack to masonry or concrete (as did I), just drill two holes, install the extension bolts in the wall, mount the rack and then tighten the bolts. The final step is to slide the hooks onto the rail and tighten these up when they're in position. The method for securing to a less burly wall is pretty much the same procedure, only you drill four holes and use screws instead.
A paper template is provided to enable you to mark up the holes appropriately, whichever installation route you choose, but unless you have a second pair of hands, it can be tricky trying to keep this planted to the wall while holding a level underneath to prevent it from sitting on a wonk. Top tip: throw this in the bin and use the aluminium bar itself to mark your holes – it's easy enough to hold and you can simply balance the level on top of it.
Once you're finished, you simply lift your bike up by its handlebar and slot it into your preferred hook. I was a little concerned that the hooks might scratch wheels, but they have a kind of rubbery coating that seems to prevent this from happening, at least so far.
The only minor issue you might encounter with this type of rack is that it's a bit narrow, so you could find that your bikes foul each other when they're hung up. Of course, this depends on the type of bike you're mounting, but I found that it took a bit of creative positioning to make all three of my bikes (road, gravel and mountain bike) fit. This orientation of bikes also makes it a little tricky to mount and dismount bikes each time, but you soon get used to it.
Pro Bike Tool actually claims this is the widest three-bike wall rack available, and this certainly seems plausible; this five-bike wall rack from Decathlon, for instance, looks incredibly tight.
In terms of value, it's hard to judge because there are so many bike storage solutions out there, and if you wanted to you could probably replicate this kind of setup using individual wheel hooks, simply by positioning them a similar distance apart.
> Buyer’s Guide: 11 of the best bike storage solutions
Depending on the type of hook you go for, you can pay anywhere between £5 and £45 – Park Tool makes a basic hook for a fiver, and we reviewed the BBB ParkingLot Storage Hook, which is now £14.95, as well as the Cycloq Endo, now a lofty £44.95. So, £60 is expensive compared with the most basic type of wheel hook, but fairly reasonable if you want to store multiple bikes and want something a little more sophisticated. And that's not to mention that none of the aforementioned hooks, or any other that I could find, are capable of accommodating really large wheel and tyre combos.
Overall, the PBT Wall Rack is smart looking and good quality, and it's nice knowing everything is included in the box for easy installation. It's also available in a six-bike version for £95, which works out a bit cheaper if you have a lot of bikes to store.
Verdict
Neat and effective way of storing multiple bikes off the ground
Make and model: Pro Bike Tool 3 Bike Wall Rack
Tell us what the product is for and who it's aimed at. What do the manufacturers say about it? How does that compare to your own feelings about it?
Pro Bike Tool says, "Free-up your floor space - Keep your garage or indoor space tidy and clutter-free. Our high-quality future proof wall hanging solution to bike storage is great for garages, storage sheds, homes and apartments. Bike rack is 33' inches (83.9cm) wide, making it the widest 3 bike wall rack in the market. Can hold bikes up to 30kg / 66.2 lbs weight load per bike."
Tell us some more about the technical aspects of the product?
From Pro Bike Tool:
Weight
1.1Kg
Dimensions
33 x 5.71 x 5 inches
83.9 x 14.5 x 12.7 cm
Material
aluminium
Compatible with standard US '2 x 4' (or '2 x '6) wooden studs (1.5' wide x 3.5' deep)
The rack will hold up to 90kg (199lb) in total, or 30kg (66.2 lb) per bike
Rate the product for quality of construction:
8/10
Lightweight, but very solid.
Rate the product for performance:
8/10
Capable of accommodating a variety of bike types and a 5-inch wheel/tyre combo.
Rate the product for durability:
8/10
Aluminium bar won't rust and the hooks look tough enough to last a lifetime.
Rate the product for weight (if applicable)
8/10
Rate the product for value:
6/10
Not as cheap as buying basic individual hooks, but the Pro Bike Tool rack offers a complete package and better features, such as the ability to fit much wider wheels/tyres.
Tell us how the product performed overall when used for its designed purpose
Bikes are easy to mount and it does its job of saving valuable floor space.
Tell us what you particularly liked about the product
It's a very neat way of storing multiple bikes together.
Tell us what you particularly disliked about the product
Nothing.
How does the price compare to that of similar products in the market, including ones recently tested on road.cc?
Park Tools makes a basic hook for a fiver, and we reviewed the BBB ParkingLot Storage Hook which is £14.95, as well as the Cycloq Endo which is £44.95. So, £60 is expensive compared to the most basic type of wheel hook, but actually rather reasonable if you want to store multiple bikes and want something a little more sophisticated.
Did you enjoy using the product? Yes
Would you consider buying the product? Yes – I have.
Would you recommend the product to a friend? Yes
Use this box to explain your overall score
The Pro Bike Tool wall rack is easy to fit and easy to use, and looks great. It can accommodate a wide variety or bikes, and the ability to fit wheel and tyre combos of up to 5 inches is nothing short of impressive.
Age: 39 Height: 6'4 Weight: 175lbs
I usually ride: Steel audax bike My best bike is:
I've been riding for: 10-20 years I ride: Every day I would class myself as: Experienced
I regularly do the following types of riding: commuting, touring, club rides, sportives,
Plenty of organisations manage to make a commercial success out of interoperability and supporting a surrounding ecosystem - this can be a selling...
Read that article yesterday, the bit that struck me was ...
Unfortunately, if someone is determined to drive whilst being disqualified, then the only way to protect the public is to keep repeat offenders in...
No doubt it will catch on in Plymouth, but it is Devon, where everything happens 10 years later. Not least the buses....
OK, but how much is the lack of decent cycling facilities already impacting people who would want to travel by cycle if only they were provided?...
GCN just did a cool video on this. All I could think by the end was that perhaps if you got to do what the presenter did and mince around Italy in...
I missed that, thanks for pointing it out. I can't comment, as that's outside my area of expertise. Apologies to Rendel. This is why they should be...
The real issue is that other people in the sport business get much more than the athletes... I also tend to agree that 8 million a year is already...
Inner width is only 13.4 mm... Will you get Shinano or Campognolo?